I have a Lone Wolf frame, but when I go to put on the slide, it stops with just about half an inch left that’s not able to go on properly. What is causing this? I don’t think it’s the take down switch bein to high. Plz helpgihhgh
top of page
bottom of page

Two out of the three FW I bult had a similar problem. I used LW parts kits with Zaffiri Precision slides.
The problem turned out to be the safety plunger not matching up with the shark fin, I swapped them out with a Rook smooth operator and fixed the problem. Just a thought you might check. You can see through the magwell if this is the problem.