Big issue on my latest build
Been putting this final build together, has been a rollercoaster, from having an out of spec locking block (which I had to file down the crossbar..) And eventually now, when I thought everything was ready and to go to the range, I noticed a big issue.
I noticed that whenever I pulled/depressed the trigger, my housing seemed to be moving up and down??? My slide also moves slightly side-to-side.
Took this video to show. Is this normal? If not what causes this? I’m confused as this has never happened to me before.
Internals:
MarineGunBuilder OEM G26 LPK, Gen 3 with G5 ejector
Glock 26 Gen 4 complete slide, All OEM
74 Views
Update: I swapped in my Geisler's trigger housing block (also an OEM marinegunbuilder G19 Gen 3 LPK with a gen 5 ejector) and put in spring etc, got it seated and put my pin in.... long story short it still wiggles up and down.. AND now is moving forward and backwards when trigger is depressed?? WTF? I always go all OEM on my builds and I'm super surprised I'm having this issue.
I changed just the part included in the photo below. I kept the same trigger and bar.
MGB kindly offered to send me a new housing, but IDK if that will help unless my issue is correlated to the trigger bar/trigger?
Also, I can't remove my Geisler's trigger pin to get the trigger out, as it seems to be stuck in there. I've hammered the shit out of it while wiggling the slide stop lever but to no avail. So this means I can't test and see if the issue is correlated to the trigger bar/trigger.