top of page

Glock Builder

Public·2002 members

Question for the builders here. Attempting a G43...holes align with 2 different jigs (DLD and P80). When attempting to mount the slide, the rails hit the back of the slide, like nearly the thickness of the rails. Even tried to mount an OEM 43x slide with the same result. Anyone run into it and know the solution?

JRMotorsports 55
Unknown member
Mar 13

If your slide goes back to the point of the rear rail but does not go any further, check shark fin angel and safety plunger. Sometimes the angle does not match up for a smoothly sliding slide on. One way to check for this is to look up though the magazine well to see if the slide stops at the point just in front of the safety plunger.

If it stops there put a long punch into the magazine well and push the safety plunger down and see if the slide slides on. Just one thing to check..

About

Welcome Patriots to the Glock Builders Group!
bottom of page